Error: "Direct draw overlay failed"

Troubleshooting, setup, and specifications for Multicam.

Error: "Direct draw overlay failed"

Postby UVS_Frank » July 11th, 2011, 1:49 pm

    Possible Causes
  1. VGA card does not support Directdraw
      Solution
    1. Update Microsoft Direct X.
    2. Update VGA card driver, if available.
    3. Replace VGA card.
Since Directdraw is required in proper video display for Multicam, this error message cannot be disabled until the problem is resolved.
UVS_Frank
 
Posts: 277
Joined: June 28th, 2011, 4:01 pm

Return to GV-DVR/NVR

Who is online

Users browsing this forum: No registered users and 1 guest